Vernice per Box

Resistant to hot tyres, engine oil stains, hydraulic oil and antifreeze.

Resistant to bad weather, frost and high temperatures.

Surfaces must be clean, dry, degreased and free of loose particles.
In case of obvious oil stains, first treat with a suitable stain remover, then apply Box Paint.
To ensure maximum adhesion, sand non-absorbent surfaces with coarse sandpaper or suitable abrasive discs.O
On damp substrates or in the presence of water counter-pressure or on oil and grease-stained floors, clean thoroughly using suitable detergent solutions and leave to dry.
Ready to use: mix the product before application.
Apply the product with a short-haired roller or brush or by spraying (diluting the product with 5% water).
Apply a second coat (diluting the product by 5% in water) after approximately 4-6 hours. If more than 72 hours elapse between coats, sand the surface with fine sandpaper to ensure good adhesion.
For greater protection, a third coat can be applied as described above.
On delicate or non-absorbent surfaces, always carry out a preliminary test on a small area of the flooring.

Tool cleaning: with water immediately after application. For daily cleaning, use a floor detergent (such as Saratoga Nettatutto) and rinse with water or a garden hose.

Keep out of reach of children. Safety data sheet available on request.

*the transparent product is milky white in bulk, becoming transparent once applied and dry