Sigilla sanitari

Waterproof.
Resistant to mould.
Easy to apply, compared to white cement or plaster.
Long-lasting result because the product does not crack over time.
Resistant to detergents.
Seals permanently, thus preventing the passage of unpleasant odours and the settlement of annoying insects.

Thoroughly clean the contact surfaces, taking care to degrease them properly (you can use alcohol or acetone); remove any traces of silicone using suitable tools such as Saratoga Sealant Remover or chemical products such as Saratoga Via Sil Hardened.
Unroll 5–10 cm of Sanitary Seal and begin application from a concealed point (this will ensure the joint remains invisible) by positioning the tip of the tape over the gap and pressing down; continue in this way along the entire edge to be sealed and cut only at the end so that the two edges fit together perfectly.
Once the application is complete, run your fingertip along the plastic film, taking care to maintain constant pressure; this will improve both the adhesion and the final appearance.