SINK SEALER is a pre-shaped, self-adhesive tape made with a special, shiny plastic which seals perfectly between the wall and the sink.

SINK SEALER goes on in an instant, with ease. It is invulnerable to mildew and can be cleaned in a snap with just a wet cloth.   

SINK SEALER does not peel or fade.

INSTRUCTIONS FOR USE:

• Clean the area between the wall and bathtub or shower stall, where the tape is to be applied, with alcohol. Surfaces should be perfectly dry. It is not necessary to remove any old sealant if it does not interfere with the areas where the adhesive part of the tape will come into contact with the surface.

• Cut SINK SEALER to the exact measurement of the joint to be sealed.

• Peel the first 10 cm. of tape off of the silicone-coated paper. Apply the tape folded at a 90 degree angle along the joint line where the wall meets the sink, pressing hard. Continue to separate the silicone-coated paper from the tape until you come to the end of the joint. 

• In the case of sinks placed on an angle, apply the tape in the same manner on both sides of the sink, laying one strip of tape over the other at the corner. You may either leave it like this, or cut both of the strips where they meet at the junction in order for them to fit perfectly (like the edges of a frame).

• After applying, press hard once again along the entire surface of the tape in order to ensure maximum adhesion.